Home » Blog » Reset HP ILO interface

Reset HP ILO interface

When updating settings on the HP ILO interface on a server i was notified that i should the settings would take place when the ILO interface was reset, but how do you reset it?

The notification message was ” There are pending changes that may not take effect until ILO is reset. ”
ilo-reset-notification

Solution

Reset the interface through SSH.

Use putty to ssh into the ILO interface ip and enter the following two lines:

cd /map1
reset

ilo-reset-ssh

Now you interface will reset and the settings will be applied.

Check Also

VMware Certified Professional – Recertification every 2 years

VMware has made some important changes to it’s certifications, this is probably affected most VCPs! …

3 comments

  1. Thx!
    could really use this, it saved my day !!

  2. Thanks for that 🙂 HP really should provide better information on this one

  3. It really works! Thanks!

Leave a Reply

Your email address will not be published. Required fields are marked *